By default, LISTSERV Maestro binds the HTTP port on all IP addresses of the server on which it is running. If the server has several addresses, then a client will be able to access the Maestro User Interface, the Administration Hub, and Maestro Tracker (depending on which components are installed) on the HTTP port by using any of the server’s addresses.
No changes to the LISTSERV Maestro configuration are required if this default behavior is satisfactory. However, to make LISTSERV Maestro bind to only a single IP address on the server, you need to edit the BindAddress entry in the Tomcat INI file:
[maestro_install_folder]/conf/tomcat.ini
Example: BindAddress=192.168.1.1
Notes:
If several LISTSERV Maestro components are installed on the same server,
then all of them will be affected by this change. It is not
possible to use different bindings for each of the components if the components
are installed on the same server. However, if the components are installed
on different servers, they can use different bindings.
This change will only be effective after a restart of the component in
question.